Rena MACH 5 Guía para resolver problemas descargar pdf (Pagina 37)

SECTION 3

OPERATING THE PRINTER

Section 3 – Operating the Printer

Control Panel Functions

BUTTON

FUNCTION(s)

ON/OFF

Press to power-up or power-down the print engine.

Note: The Main Power Switch must be ON, to power-up the print engine.

POWERING-UP: After pressing this button; it takes approximately 45 seconds for the

print engine to power-up. All lights blink simultaneously during power-up sequence.

The ON/OFF button will change to a steady illumination condition, once the print engine

is fully powered-up.

Tip: You can launch (open) the Toolbox utility after the lights come on.

POWERING-DOWN: Before turning off the printer, using the Main Power Switch;

please be sure to power-down the print engine using this button. When the print engine

has completed its power-down cycle, all lights in the control panel will turn off

. It is now

safe to turn off the Main Power Switch.

WARNING! If you need to Turn OFF/unplug the printer. Please be sure the Print Engine

is powered-down (all LED’s out) before turning OFF the Main Power Switch.

If this power-down process is not followed; printhead nozzle clogging and reduced head

life may result.

IMPORTANT: For best system performance, it is recommended to keep the print engine

powered-up (ON/OFF light illuminated) at all times.

PAPER/RESUME

PAPER (Paper Feed Test): Before sending data to the printer; you can perform a paper

feed test by pressing and holding this button for 5 seconds. A single piece will be fed.

RESUME: If a paper feed condition (paper jam, out of paper, etc.) was detected; clear the

jam, reload media and press this button to resume printing.

If the printer was paused using the PAUSE/CANCEL button, press this button to resume

printing.

PAUSE/CANCEL

PAUSE: If you are in the process of printing and you want to pause the print job, press

this button once.

If the printer was paused, using the PAUSE/CANCEL button, press the RESUME button

to resume printing.

CANCEL: If you want to cancel a paused print job, press this button again. The print job

will be cleared from the printer and print queue in the driver. NOTE: In some cases you

may need to manually clear (delete) the documents from the driver’s print queue.

Please see “Printer Status Light Indicators”, on next page, for additional information.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 127 128

Sin comentarios

Rena MACH 5 Guía para resolver problemas Pagina 37