Rena DA615 Manual de instrucciones descargar pdf (Pagina 17)

DA615 Operations Manual 3 Rev. 3/23/00

Address Positioning

The DA615 has two print head modules (units). Both units contain two C 6131A (HP 51645A) cartridges. Each unit is

capable of printing up to 1 inch high, or 6 lines, at 6 lines to the inch.

These units can be “linked” allowing an operator to print a solid block of 12 lines (2 inches high) or they can be

positioned independently allowing the operator to print two independent blocks of 6 lines (two, one inch high blocks).

Loosen the thumbscrews (3) to move units. Tighten the thumbscrews (3) to keep units from moving.

Linking Heads (Linking Units)

To “link” the units, the left unit (H3&H4 (labelled as DB3-4)) must be positioned 1 inch (25.4mm) farther out from the

back wall, than the right unit (H1&H2 (labelled as DB1-2)). This difference in head unit position is shown above as

dimension (V). For example, if the right unit is set to 1 inch, the left unit should be set to 2 inches. A measurement

scale is provided on the sides of each of the Head Positioning Shafts (Sk). Use the value at the front edge of the block.

Positioning Heads to Print Two Independent Blocks (S/N 130 or lower)

If it is desired to print two 1-inch high blocks of information, than the units must be positioned at least 3 ½ inches

(87mm) apart (V). This is done to avoid the image printed by one unit being damaged by the pressure rollers of the

other unit. However, it is possible, to move the two units closer together (less than 3 ½ inches) if you are not printing a

full inch block on one or both of the units. For example if Head 1&2 (DB1-2) are printing an image that is only ½ inch

high, you can reduce the distance (V) by ½ of an inch.

NOTE: By using the menu items First Unit, Orientation and Top Margin, many other head configurations can be

accomplished to avoid the image printed from one unit running under the pressure rollers from the other unit. Some

experimentation will be necessary to find the best settings to meet your needs.

Heads “Linked” V=1 inch (25.4mm) Heads positioned to print

two 1-inch high blocks.

V = 3 ½ inches (87mm)

KEY

P-Li = Paper Sensors Left & Right

DA615’s S/N 131 or higher are

equipped with two left and two right

paper sensors. The material only needs

to pass over one of the two sensors

(one right and one left).

DA = Head Unit

DB1-2 = Head 1 & Head 2

DB3-4 = Head 3 & Head 4

3 = Securing Knob (Thumb Screw)

4 = Transport Pressure Adjustment

D = Material (Envelope)

Sk = Head Positioning Shafts.

Feed Direction

Only present in

S/N 131 or higher.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

Sin comentarios

Rena DA615 Manual de instrucciones Pagina 17