Rena MACH 5 Guía para resolver problemas descargar pdf (Pagina 16)

SECTION 2

INSTALLING THE PRINTER

3. Attach the Rear Media Support Guide using the

knob [3] provided.

The two outer holes in the guide fit over the

socket head screws; as shown.

4. Install the desired Media Support Wedge using the

mounting hardware [4]; as described below.

Choose the appropriate Media Support Wedge for your

application:

Wide Media Support Wedge [5]

– For media that is 8 inches wide or greater.

Narrow Media Support Wedge [6]

– For media that is less than 8 inches wide.

The Anchor Plate [7] fits into the slot, from the underside

of the Rear Media Support Guide. Position the Media

Support Wedge so the upper and lower holes fit onto the

two tabs from the Anchor Plate.

The washer [8] goes between the Thumb Screw [9] and

the Media Support Wedge. The Thumb Screw is inserted

down through the washer, then through the center hole in

the Media Support Wedge and into the threaded hole in

the Anchor Plate. Tighten the thumb screw to secure the

Media Support Wedge onto the Rear Media Support

Guide.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 108 109

Sin comentarios

Rena MACH 5 Guía para resolver problemas Pagina 16