search

Rena MACH 5 Guía para resolver problemas Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 109
  • Tabla de contenidos
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
SECTION 3
OPERATING THE PRINTER
32
Printer Status Light Indicator Chart (see legend)
Valid with Firmware 110928_u or higher installed.
ON/OFF
PAPER
RESUME
PAUSE
CANCEL
Printer Status
corresponding Toolbox message
Additional Details, Possible Solution or Action
OFF
OFF
OFF
Print engine is powered-OFF
In this condition, it is safe to turn the Main Power Switch OFF or ON.
IMPORTANT: To provide proper printhead and ink system
maintenance; the printer should remain powered on (ON/OFF light
illuminated) at all times.
ON
OFF
OFF
Print engine is powered-ON and ready
Printer is Ready
/
/
/
Print engine powering-up
It takes approximately 45 seconds for the print engine to power-up;
after pressing this button.
All lights blink simultaneously during power-up sequence.
The ON/OFF button will change to a steady illumination condition,
once the print engine is fully powered-up.
TIP: You can launch (open) the Toolbox after the lights come on.
Print engine powering-down
All lights blink simultaneously during power-down sequence.
Wait until all lights go out before turning OFF the Main Power
Switch.
ON
/
/
Busy: Job Loading Wait for lights to stop blinking.
Printer is Performing Maintenance
(Cleaning, Circulating Ink, etc..)
Toolbox = MAINTENANCE_BUSY
Wait for lights to stop blinking.
Canceling Job. CANCEL key was pressed
Toolbox = MECH_CANCELJOB
Wait for lights to stop blinking.
ON
/
/
Printer is Printing
Press PAUSE, to pause printing.
TIP: If the printer doesn’t try to feed media; check for paper jam in
print engine and clean the PaperPath sensors.
Please see the “Toolbox System Status Messages” section for more details on Toolbox messages.
Simultaneous Flash (1/sec)
Simultaneous Flash (1/sec)
Alternating Flash (1/sec)
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 108 109

Comentarios a estos manuales

Sin comentarios
Relacionado con productos y manuales para Impresión y escaneo Rena MACH 5
Impresión y escaneo Rena Mach 8 Información técnica   (10 paginas)
Impresión y escaneo Rena Envelope Imager XT 3.0 Guía para resolver problemas   (56 paginas)
Impresión y escaneo Rena DA-590 Guía de usuario   (130 paginas)
Impresión y escaneo Rena Envelope Imager XT 4.0 Manual de usuario   (1 paginas)
Impresión y escaneo Rena DA615 Manual de usuario  (24 paginas)
Impresión y escaneo Rena DA615 Manual de instrucciones   (82 paginas)
  • Xircom AIAIAI Duratech WERTHEIM Consew
  • Nikon Flashes de las cámaras Konftel Teléfonos Denon Las radios Lenovo Tabletas Bosch Teclados
  • Hp 3970 Monster iCarPlay Direct Connect 2000 Sony RDR-HX680 Parabody cm3 Sony VCT-STG1
  • Aeg AT7800 Manual de usuario ASROCK A785GM-LE Manual de usuario Panasonic RFP150 Instrucciones de operaciones Humminbird AD STM 7 Especificaciones Ridgid TS2400LS Manual de usuario